1/30/2024 0 Comments O2j transmission bolt sizesThe car was purchased brand new by a friend of ours and he was the sole owner so we are very sure of the engines history, (for whatever merit that has in regards the bell housing bolt specs (Since I’m neck deep into a Super Charged traditional SBC V-8 Z project now, don’t you all think that Ron should take on a Mid Engine LS-1 Z project? He already has a 240 Z shell modified for an L-6 mid engine set up…) Any how, this engine was pulled directly from said 2000 C-5 Vette, set on a wooden crate that sat in my barn for a couple years and as of last week installed on this engine stand pictured above. Ron then stipulated to me that whoever starts a project worthy of this engine first, gets to use it. Ron Tyler then acquired the original C-5 engine in trade for helping tune the chassis for maximum effort SCCA Solo-II Super Stock competition. After quite some time, he broke a valve spring then bought a “new” stock LS-1 from GM to meet “Super Stock” class rules for SCCA Solo-II. This engine received a cam, ported heads, LS-6 intake and exhaust mods, (produced 379 RWHP when all said and done). ![]() Our engine is an LS-1 out of a 2000 C-5 Corvette purchased brand new by a friend of ours. Here is what I’ve got thus far… (Maybe we should query the V-8 forum about this as well?) Our fingers are crossed that all is well…. My guess would be that if a reputable shop sent you bolts for the bell housing, they should indeed be the correct bolts and those bolts should be 10mmx1.5, which is really close to 3/8†x16. If you have an old Datsun engine laying around, use one of the main bolts or head bolts and thread it into a bell housing hole that you have not put a bolt into yet. The 10mm x1.5 will go in all the way by hand. SAE 3/8†x16 bolts will go in approx ½-1 ½ revolutions by hand before they get too tight for finger insertion. The engine is a crate motor and has only sat in the wooden crate and not on a stand. To tell you the truth I didn't realize they were SAE bolts until I checked them with a pitch guage for this thread. ![]() I am using the bolts that Keisler engineering sent with the LS housing I bought from them. So far the bellhousing has only been set finger tight while I am fabbing mounts.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |